Using the RAK5010 with Traccar

Kosnb 5 years ago

Hello there,
I guess you need to specify where you stuck.

zjonesz 5 years ago

What protocol/Port?
And should i use for Identifier?

HEX:

0a4163633a31352e30302c37322e30302c2d3939322e30303b2054656d3a33302e37333b48756d3a33322e36363b205072653a313032312e36303b204c69673a322e34363b204c617428302d4e2c312d53293a302c353930312e3730353031372c4c6f6e28302d452c312d57293a302c3630332e3431373537343b20426174746572793a342e33303b

Decoded Hex:

Acc:15.00,72.00,-992.00; Tem:30.73;Hum:32.66; Pre:1021.60; Lig:2.46; Lat(0-N,1-S):0,xxxx.xxxx17,Lon(0-E,1-W):0,xxx.xxxxx74; Battery:4.30;

Thanks

Kosnb 5 years ago
  • What protocol/Port?
  • Open the configuration file and look for RAK5010 and it's corresponding port.
  • And should I use for Identifier?
  • To get the device identifier, use send a message to the number in your device. The content of the message should be "imei+password". For example, if the password is 123456, send "imei123456". Please do not include the quotes "" in the message.
zjonesz 5 years ago

There are no RAK5010 in the configuration file. (default.xml)

Kosnb 5 years ago

@zjonesz Were you able to get the identifier? Have you tried port 5001 or 5002? Remember to send GPRS+password to switch to GPRS mode.