Ground Sense State in Teltonika
Once ground sense is enabled set it in the IO's in config. Then on server look for io381
Hi,
I enabled the ground sense in I/O in config. I fix the device in vehicle but it does not show in position attributes io381.
Do you have DIN2 connected to ground
Make sure input mode is set to "Ground Sense"
Then in IOs set ground sense to high on change.
If you then disconnect and connect DIN2 it should send position to server and io381 should be 1
Yes
Is the extended codec 8 avilitated? Otherwise that avl value is not sent
Dear Team,
I activate 'ground sense state' in teltonika configurator but it does not show in position->attributes.