Gentlemen, I've been trying for days to figure out how to get the J16 device to send odometer and time meter data correctly to Traccar.
Throughout my research, I discovered that Traccar doesn't support the 0x32 format, which is the format of the device in question.
I've already tried creating a proxy that converts 0x32 → 0xA2 (it seems that only this one is supported by Traccar). However, I'm having a lot of difficulty getting this data.
So I ask, is there any native support from Traccar for this device?
It's widely used in Brazil due to its low cost and efficiency, but it's very difficult to collect this information.
Thank you for reading!
Do you have the protocol documentation and some data samples?
Here's an example of the data. But I don't have any official documentation.
78 78 2c 32
19 0c 0d 0d 19
2a c8
00 46 31
7c
00 00 00 00
8f 6b 28 00
0b e4
e6 d1
74 34
01
00 00 00 00
00
01
04 c4
29 00 00
19 12
e4 1f
31
0d 0a
Message type 0x32 seems to be supported, but obviously without documentation it's impossible to tell if it's the right format.
Gentlemen, I've been trying for days to figure out how to get the J16 device to send odometer and time meter data correctly to Traccar.
Throughout my research, I discovered that Traccar doesn't support the 0x32 format, which is the format of the device in question.
I've already tried creating a proxy that converts 0x32 → 0xA2 (it seems that only this one is supported by Traccar). However, I'm having a lot of difficulty getting this data.
So I ask, is there any native support from Traccar for this device?
It's widely used in Brazil due to its low cost and efficiency, but it's very difficult to collect this information.
Thank you for reading!