ST-915L Battery Level

Hello,

I am using an ST-915L with the H02 protocol.

Where in the Traccar manager is the battery level information displayed?

Your help is greatly apricated.

Thank you,
Jason

In the state panel.

Hello again Anton,

Hope all is well.

I looked there but there is nothing labeled "Battery".

Some are labeled as such;

Io1 - 310
Io2 - 00
Io3 - 22035
Io4 - 10964995
Io5 - 100

Could you please identify what these field reading represent?

Thanks again,
Jason

Does one of those values look like battery? If not, your device probably it's reporting it.

Manufacturer shows it supports battery level.

Would changing the protocol address this?

Have you checked the raw data from logs? Does it have some extra information that wasn't decoded?

I will get back to you on that.

Thank you,
Jason

So I was able to determine that the Io5 is the battery level output in the State section.

How do I rename the "Io5" to "Battery Level"?

Much appreciated,
Jason

You can use computed attributes.

That did it.

Thank you,
Jason

thanks to both of you. had the same question.

How have „computed attributes“ to be configured in Detail for this?