ZX908 Getting started
You should configure the device to point to your traccar server. Make sure the service device port is accesible from the internet.
Thx so far. I did already read the guide. Unfortunately there was no manual of the zx908 included. How do I configure the client? Via USB oder is there a UART port?
That's something you should read in the device manual.
That is the issue. I didn't get one and cound not find one. Any ideas?
You bought a device and it didn't come with a manual? Have you asked the seller?
It's aliexpress. I tried but no response. It was Just the board without battery or case. Only IMEI sticker on it
Wait. So it it a tracking device or just a clean board?
Clean Board
Any Ideas or links?
Hi,
thats the manual
I found for the ZX 908.
I got it working with traccar by using port 5023 (GT06), 5199 works as well.
The problem is, it won´t wake up after it became stationary for a while. Seems to be a common problem.
That´s not an issue on the 365gps server.
Hi, i've the ZX905, which is similar i think, since last week.
Here are the sms commands I've sent to the tracker to set it up to my traccar server:
APN,internet.t-mobile,,# insert the correct apn
SERVER,XXX.XXX.XXX.XXX,5199# put in ip
TIMEZONE,0#
TIMER,30,3600# post datta 30s if moving, 3600s if not
Now the tracker talks to my server...
BR
MrFX
I used
SERVER#xxx.xxx.xxx.xxx#5199#
for 908
@ Felix Richter
did you encounter any issues regarding the "wake up problem" I mentioned before with your 905 board?
Hey i ordered and recieved my ZX908 from aliexpress. I installed the traccar Docker on my seerver and the server ist running fine so far. I did insert a SIM in to the ZX908. but now i dont know how to connect the ZX908 with my server. Is ther already the correct softwar/firmware on the ZX908 or do i have to flash a new one? and how? Would be very thanksfull for the community for some hlep.