Help Traccar Server DigitalOcean

Hi.

I have installed traccar in a DigitalOcean droplet, but not being able to use it. Can you help me please. Thank you.

I nmap the port 8082 from my PC and this is what I get:

nmap -p 8082 138.68.XXX.151
Starting Nmap 6.40 ( http://nmap.org ) at 2017-05-20 16:43 COT
Nmap scan report for 138.68.XXX.151
Host is up (0.16s latency).
PORT     STATE SERVICE
8082/tcp open  blackice-alerts
Nmap done: 1 IP address (1 host up) scanned in 0.50 seconds

But whet try to use it in the web browser http://138.68.XXX.151:8082/ it says

Please log into your droplet via SSH to configure your LAMP installation.

And this is in my server

root@lamp-2gb-sfo2-01:~# ufw status verbose
Status: active
Logging: on (low)
Default: deny (incoming), allow (outgoing), disabled (routed)
New profiles: skip

To                         Action      From
--                         ------      ----
22                         LIMIT IN    Anywhere                  
443                        ALLOW IN    Anywhere                  
80                         ALLOW IN    Anywhere                  
8082/tcp                   ALLOW IN    Anywhere                  
8082/udp                   ALLOW IN    Anywhere                  
8082                       ALLOW IN    Anywhere                  
22 (v6)                    LIMIT IN    Anywhere (v6)             
443 (v6)                   ALLOW IN    Anywhere (v6)             
80 (v6)                    ALLOW IN    Anywhere (v6)             
8082/tcp (v6)              ALLOW IN    Anywhere (v6)             
8082/udp (v6)              ALLOW IN    Anywhere (v6)             
8082 (v6)                  ALLOW IN    Anywhere (v6)   




nano /etc/apache2/ports.conf 

Listen 80

Listen 8082

Listen 138.68.XXX.151:8082

<IfModule ssl_module>
        Listen 443
</IfModule>

<IfModule mod_gnutls.c>
        Listen 443
</IfModule>

# vim: syntax=apache ts=4 sw=4 sts=4 sr noet

I don't understand how Apache is related to Traccar.

Hi. I just posted all the information, in case it is needed.

I have the ports already open, but cannot use traccar.

Obviously it can't use it because you have Apache running on that port.

Thank you very much. It fixed the issue.
I haven't seen what your are using for geofences, ¿but have you considered http://www.geotools.org/?
I have used it to calculate the distance from a point to a polyline (route).

I'm not sure why we need to consider it if we already have everything implemented.