Hi,
I’m able to see the "Fuel" value in both the popup information and the reports/charts.
I’m using an FMC125 and reading the fuel level from io9. The analog fuel sensor has been calibrated, and I’ve created a calculated attribute for "fuel" using my calibration table and some expressions shared on the forum.
My understanding is that "Fuel Consumption" and "Fuel Used" should be calculated automatically once the fuel attribute is available.
However, I cannot see either of them in the popup info or in the report charts. I also couldn’t find any clear method from the forum to calculate these two metrics using calculated attributes.
If I’m mistaken, could you please advise on how to make both attributes appear in the pop-up info and reports?
What makes you think those are calculated automatically?
If I am not wrong.
Fuel used = previous fuel level - current fuel level. I got "fuel" as calculated attribute.
Fuel Consumption: FuelUsed / (TotalDistance/1000).
Please answer my question first.
Anton,
Thank your for asking the question to get more clarification.
The logic behind the formulas I wrote in earlier reply made me think those are calculated automatically.
Where did you get those formulas? I'm trying to understand what evidence you had to make this assumption.
Hi,
I’m able to see the "Fuel" value in both the popup information and the reports/charts.
I’m using an FMC125 and reading the fuel level from io9. The analog fuel sensor has been calibrated, and I’ve created a calculated attribute for "fuel" using my calibration table and some expressions shared on the forum.
My understanding is that "Fuel Consumption" and "Fuel Used" should be calculated automatically once the fuel attribute is available.
However, I cannot see either of them in the popup info or in the report charts. I also couldn’t find any clear method from the forum to calculate these two metrics using calculated attributes.
If I’m mistaken, could you please advise on how to make both attributes appear in the pop-up info and reports?