Teltonica FMB900 Analogue input

Hi,

I'm testing traccar with a Teltonica FMB900. I can see from the teltonica control/config app that it is detecting different voltages on the Analogue Input. My question is how do I retrieve this input in traccar. I was expectiong it to be displayed on attribute io200, but that's consistently at 0.

Do I need to add some configuration to the traccar.config to pass these values in? From looking at the documentation I believe the parameter ID is 50180

Thanks

Andy

You don't need to change any Traccar configuration.

Ok thanks for confirming that, do you have any suggestion on how I might be able to read the values from the analogue input?

If you don't see it already, then it's likely a device issue. So you should probably talk to Teltonika support.

@Andyw
You must told teltonika that it must send this data. You can do this in I/O section in Teltonika Configurator.

Thanks Lukasz, yes I'd figured that out and it's now working as expected. My issues was it was set to event only.