Your sample works for me just fine.
Thanks for your reply. Good to know it should work.
Back to the "drawing board" then .
After reading the basics again, the Identifier was incorrect and required the full IEMI number as the identifier.
Now the device decodes.
I assumed that if the port was correct the decoder would work without the correct identifier.
Thanks Anton
Hi
I have purchased the gps traccar above which is an Eelink protocol device but it does not work .
the Hex output looks like Eelink
676702002503dc5c0d1ef8fcfe490f1074fb4500000001f900015250dd21d501006b119d000c04f40000
Any ideas on how to get it to be recognised would e helpful.
Thanks
Brad